Hoover HGO300 HYDRO Manuel D'utilisation page 5

5
GETTING TO KNOW YOUR ROBOT CLEANER
23
24
25
26
27
28
PREPARE YOUR ROBOT CLEANER
PACKAGING
Do not dispose of your Robot packaging. It may be required the validity of your guarantee in the future.
When unpacking your Robot and its accessories, take care to keep plastic bags away from babies,
young children and animals to avoid the risk of suffocation.
$GHQTG TUV WUG EJCTIG [QWT CRRNKCPEG HQT  JQWTU [Fig. 1]
From the second charge, it will take 4-5 hours to be fully recharged.
&Q PQV GZRQUG VJG 4QDQV U OCKPU RQYGT CFCRVQT VQ VGORGTCVWTGU DGNQY u% QT CDQXG u% CU VJKU
may damage the battery.
The mains power adaptor must only be connected to a standard mains power outlet.
BATTERY
For optimum battery performance it is recommended that you keep your robot batteries fully charged.
When the robot is not in use it should be left connected to the mains power adaptor. The robot has an
intelligent charging system. This prevents the batteries from becoming overcharged.
To avoid accidents, make sure that every person in the room is aware of the presence of the robot.
Charging Station Setup
Fig. 1
Before use, remove obstacles that may get in the path of the Robot. Pay attention to:
• Objects that can be easily knocked over.
• Edges of carpets or rugs that it may get caught on.
• Floor length curtains and tablecloths.
*GCV UQWTEGU QT COOCDNG KVGOU
• Power cords and cables.
• Fragile objects.
Plug in the mains power adaptor and connect to the charging station. [Fig. 2]
1. Make sure the power cord is not caught underneath the charging station.
 2NCEG VJG EJCTIKPI UVCVKQP QP C PQPTG GEVKXG NGXGN QQT RTGHGTCDN[ CICKPUV C YCNN +H VJG QQT
UWTHCEG KU VQQ TG GEVKXG KV YKNN KPVGTHGTG YKVJ VJG 4QDQV PCXKICVKQP U[UVGO CPF KV OC[ JCXG FKH EWNV[
locating the charging station.
3. There should not be any objects in the area around the charging station for 2 meters in front and 1
Fig. 2
meter to each side. [Fig. 2]
4. Make sure the power cord is not tangled or stretched. If there is an excess, use the power cord tie
to store it neatly.
5. Check that the dust container is inside on Robot.
6. Press the two rotary brushes labelled L and R onto the brackets until they click into place. Pay
attention to the designation L and R on the device as well as the brushes. [Fig. 3]
7. Guide your Robot into the charging station to begin. During normal use, it will take approximately
4/5 hours to complete a full recharge.
NOTE: $GHQTG TUV VKOG WUG VJG DCVVGTKGU OWUV DG EJCTIGF HQT CV NGCUV  JQWTU
Fig. 3
34
23 Trasmitter Diode
24 Suction Power
25 Button Forward
33
26 Button Left
32
27 Scheduling Button
28 Charging Station Button
31
29 Timing Setting Button
30
30 Button Backward
31 Button Right
29
32 Start/Pause Button
33 Mode Button
34 Display
* Certain Models Only ** May vary according to model
GB