Progress Lighting 5759 Instructions De Montage Et D'installation

LIGHTIN
WARNING • To comply with the National Electric Code and Underwriters Laboratories requirements, the edge of the wall
plate coming in contact With the mounting surface must be sealed with a latex waterproof caulking to prevent water from
entering the outlet box.
WARNING - If any Speaal Control Devices are used with this Fixture, Follow the Instructions Carefully to assure full
compliance with N.E.C. requirements.
WARNING - This product contains
other reproductive harm. Thoroughly wash hands after Installing, handling, cleaning, or otherwise touching this product.
6
1 3
2
1.— Fasten Mounting Strap (3) to Outlet Box (I)(NOT
2.— Thread Nipple (5) and Green Ground Screw (9) into
3.— Connect Fixture Wires (4) to Supply Wires (2) as shown in Wiring
Slip Cage Assembly (7) over Nipple
5.— Place Glass Panels (11) into
6.- Install Lamp (NOT FURNISHED).
Assembly & Installation
CAUTION: Read instructions
circuit
5759,
If there are any questions,
chemicals known to the State of California
4
9 5
FURNISHED) with Mounting
(5) and secure in place with
Cage Assembly (7) and bend Top and Bottom
carefully
breaker panel before beginning installation.
5760
contact a Qualified
to cause cancer, birth defects and /or
7
10
11
10
8
Mounting Strap (3).
Diagram.
Capnut (8).
Tabs (10) against
PAGE 1
Instructions
and turn electricity
Electrical Contractor.
WHITE SUPPLY WHITE OR IOENTIFIEO
WIRE FIXTURE
BLACK SUPPLY PLAIN
WIRE FIXTURE
BARE, OR GREEN BARE, OR GREEN
GROUND WIRE F XTURE
FROM SUPPLY
OR
BARE, OR GREEN
GROUND WIRE
FROM SUPPLY
(NOT FURNISHED)
(NO INCLUIDA)
(NON FOURNIE)
Screws (6) from Outlet Box (1).
Glass to secure.
SPEC.NO. 023790
off at main
WIRE
UL LISTED
WIRE NUTS
OR BLACK
WIRE
GROUND
WIRE
GREEN GROUND
SCREW
02-11-09