Construction And Function; Dimensions - Balluff BOD 21M- -S92 Série Notice D'utilisation

BOD 21M-...-S92
Photoelectric Sensors – Laser Distance Sensor
Safety (continued)
Note:
LASERSTRAHLUNG
NICHT IN DEN STRAHL BLICKEN
Max. Leistung (peak):
Impulsdauer:
Wellenlänge:
LASER KLASSE 2
DIN EN 60825-1:2008-05
A laser warning sign in the appropriate language
must be applied directly to or near the sensor.
This sign must be readable at all times without
causing the operator to look into the laser
beam!
Disposal
This product falls under the current EU
Directive for WEEE, waste of electrical and
electronic equipment for protecting you and
the environment from possible hazards and
responsible handling of natural resources.
Dispose of the product properly and not as part of the
normal waste stream. Observe the regulations of the
respective country. Information can be obtained from the
national authorities. Or return the product to us for
disposal.

Construction and function

Dimensions

www.balluff.com
1,2 mW
4 ms
650 nm
Connection
– Do not switch the two push-pull switch
outputs (pin 2 and pin 4) in parallel!
– An R/C (CYJV2) cable with suitable
properties is to be used to connect the
sensor.
Plug diagram
(Top view of the plug on the BOD)
BOS 21M-LA...
BOS 21M-LB...
Analog signal
The value of the analog signal depends on the distance to
the object and the configuration of the analog output.
BOS 21M-LA...
BOS 21M-LB...
a = Linearity
b = Measuring
range
c = Undefined
range
english 2