What To Do If - Becker Centronic TimeControl TC42 Notice De Montage Et D'utilisation

Problem
Drive is not functioning.
Drive is running in the
wrong direction.
Astro program is not
switching accurately.
The control unit does
not carry out the set
switching commands.
The control unit does
not carry out the set
switching commands
accurately.
Shading solution does
not travel to end posi-
tion.
BATTERY appears on
the display.
48 - en

What to do if...?

Cause
Incorrect connection.
Incorrect connection.
Date is incorrect.
Incorrect city or incor-
rect degree of latitude/
longitude set.
Holiday function
switched on.
Astro shift is set.
The slide switch is set to
Manual mode.
Holiday function is
switched on.
End position not set.
Battery is low.
Remedy
Check connection.
Swap over wire
wire on the power
supply unit.
Set correct date.
Set correct city or exact
degree of latitude/lon-
gitude.
Switch off holiday func-
tion.
Adjust Astro shift.
Set the slide switch to
Automatic mode.
Switch off holiday func-
tion.
Set the end position in
the PROG END POSI-
TION SETTING menu.
Insert a new battery.
and