Attaching And Removing The Saw Blade; Using The Parallel Guide - Parkside Performance Psspa 20-Li E3 Traduction Des Instructions D'origine

GB MT
Switch (dust blower function) (7)
Blower function for chip-free cutting
line
⭠
enable
Lever (6)
Bevel cutting, p. 35
Attaching and removing the
saw blade
CAUTION! Risk of injury
when touching the saw blade.
Wear protective gloves when
handling the saw blade.
Requirements
• The saw blade has a T-shank
mount (single lug shank) like the
supplied saw blades (16/17).
• The saw blade is suitable for the
respective material.The scope of
delivery for the device includes
large-toothed saw blades for wood
and a fine-toothed saw blade for
metal and plastic.
• The chuck is free of splinters or
other material residue.
Installing the saw blade (Fig. B)
1. Turn the release of the chuck (14)
as far as possible. Keep the re-
lease of the chuck fixed in this po-
sition.
2. Place the saw blade (16/17) in-
to the chuck (21).When inserting
the saw blade, make sure that the
back of the saw blade is in the
notch of the guide roller (15).
3. Release the release of the chuck
(14) los.
4. Make sure that the saw blade (16/
17) is attached correctly and the
34
Removing the saw blade (Fig. B)
Hold the device in a way that no per-
sons in the vicinity are injured by the
ejected saw blade.
⭢
1. Hold the saw blade (16/17) firmly.
disable
2. Turn the release of the chuck (14)
3. Release the release of the chuck

Using the parallel guide

The parallel guide can be fitted on
both sides of the tool.
Fitting the parallel guide (Fig. C)
1. Loosen the retaining screws (20) if
2. Push the parallel guide (28) into
3. Retighten the retaining screws
Removing the parallel guide (Fig. C)
1. Loosen the retaining screws (20).
2. Pull the parallel guide (28) out of
Adjusting the parallel guide (Fig. C)
1. Loosen the retaining screws (20).
2. Set the scale on the parallel guide
3. Retighten the retaining screws
4. Make a test cut, check the cutting
teeth are pointing in the cutting
direction.
as far as possible.
The saw blade (16/17) is ejected.
If the saw blade is not ejected:
Hold the release of the chuck and
pull the saw blade from the chuck.
(14) los.
necessary.
the holders (18).
(20).
the holders (18).
(28) so that you can read the de-
sired cutting width on the mount
(18) marking.
(20).
width and correct the position of
the parallel guide (28) if necessary.