Bevel Cutting; External Dust Extraction; Attaching And Removing The Splinter Guard; Checking The Battery Charge Level - Parkside Performance Psspa 20-Li E3 Traduction Des Instructions D'origine

Bevel cutting

Notes
• You can set the following cutting
angles:
−45°; −22.5°; 0°; 22.5°; 45°
Procedure (Fig. D)
1. Switch off the device and remove
the battery. Make sure that all
moving parts have come to a com-
plete stop.
2. Remove the splinter guard (19).
3. Open the lever (6).
4. Push the footplate (12) forwards
slightly.
5. Adjust the footplate (12) to the de-
sired position.
6. Press the footplate (12) backwards
into one of the notches.
7. Close the lever (6) fix the position.

External dust extraction

Connecting external dust extrac-
tion (Fig. E)
1. Disable the dust blower function
(7).
2. Slide the adaptor for external dust
extraction (11) as far as it will go
into the guide rail between the
device and baseplate (12).
3. Connect a suitable dust extraction
(not included) to the adaptor for
external dust extraction (11).
4. If the external dust extractor does
not fit, use the additional reducer
(10).
Removing the external dust extrac-
tion (Fig. E)
1. Remove the dust extraction from
the adaptor for external dust ex-
traction (11) or reducer piece (10).
2. Remove the reducer piece (10) and
the adaptor for external dust ex-
traction (11).
Attaching and removing the
splinter guard
Attaching the splinter guard
1. Push the splinter guard (19) from
the bottom into the recess in the
baseplate (12).
Removing the splinter guard
1. Press the splinter guard (19) away
from the recess in the baseplate
(12).
Checking the battery
charge level
LEDs
red, orange, green Battery charged
red, orange
red
1. Press the button (32) next to the
charge level indicator button (30)
on the battery (9).
The LEDs of the charge level in-
dicator show how much charge re-
mains in the battery.
2. Charge the battery (9) when only
the red LED on the charge level in-
dicator (30) is illuminated.

Charging the battery

See also the charger instruction
manual.
Notes
• If warm, allow the battery to cool
before charging.
• Do not expose the battery to dir-
ect sunlight for long periods and
do not place it on a radiator (max.
50°C).
Charging the battery
1. Remove the battery (9) from the
device.
GB MT
Meaning
Battery partially
charged
Battery needs to
be charged
35