Télécharger Imprimer la page
LEGRAND WIREMOLD RFB Serie Notice D'installation
Masquer les pouces Voir aussi pour WIREMOLD RFB Serie:
No: 1025916-RB-1022
Catalog Number(s) • Numéro(s) de Catalogue • Número(s) de Catálogo:
Floor Boxes: • Boîtes de sol : • Cajas para piso:RFBA10R55, RFBA10R55OG, RFBA10C55, RFBA10C55OG
Covers: • Couvercles : • Cubiertas: FPLCTCAL, FPLCTCBK, FPLCTCBS, FPLCTCBZ, FPLCTCGY, FPLCTCNK, FPLBTCAL,
FPLBTCBK, FPLBTCBS, FPLBTCBZ, FPLBTCGY, FPLBTCNK, 8CT2BK, 8CT2GY, 8CT2BZ, 8CT2AA, 8CT2SB, 8CT2SN, 8CTC2BK,
8CTC2GY, 8CTC2BZ, 8CTC2AA, 8CTC2SB, & 8CTC2SN
Device Plates: • Plaques du dispositif : • Placas de dispositivo: RFBAB, RFBADP, RFBADEC, RFBAS1, RFBAS2,
RFBA6A, RFBAAAP
Device Plate Adapters: • Adaptateurs de plaque du dispositif : • Adaptadores de placa de dispositivos: RFBA10-2G, RFBA10-3G
Bare Concrete & Terrazzo Ring: • Anneau pour béton nu et terrazzo : • Aro de hormigón y terrazo visto: 8CT-CTR
Extension Ring: RFBA610R4EXT, RFBA610C4EXT
Floor Structure: Concrete • Structure du sol : béton • Estructura del piso: hormigón
Floor Surface: Carpet, Tile, Wood, Polished Concrete, and Terrazzo • Surface du sol : moquette, carrelage, plancher, béton poli et
terrazzo • Superficie del piso: alfombra, baldosas, madera, hormigón pulido y terrazo
Country of Origin • Pays d'origine • País de origen:
Floor Boxes • Boîtes de sol • Made in USA • Fabriqué en USA • Hecho en EE. UU.
Covers, Device Plates, Furniture Feed Kit, Bare Concrete & Terrazzo Ring – Made in USA & India
Couvercles, plaques, kit d'alimentation de meubles, anneau pour béton nu et terrazzo – Fabriqué en USA et India
Cubiertas, Placas de dispositivo, Kit de alimentación para muebles, Aro de hormigón y terrazo visto – Hecho en EE. UU. e India
IMPORTANT:
PLEASE READ ALL
INSTRUCTIONS BEFORE
BEGINNING INSTALLATION
Legrand electrical systems conform to and
should be properly grounded in compliance with
requirements of the current National Electrical
Code or codes administered by local authorities.
All electrical products may present a possible
shock or fire hazard if improperly installed
or used. Legrand electrical products may
bear the mark of a Nationally Recognized
Testing Laboratory and should be installed
in conformance with current local and/or the
National Electrical Code.
WIREMOLD
RFB Series Floor Boxes
Boîtes de sol série RFB
Cajas para piso serie RFB
Installation Instructions • Notice d'Installation• Instrucciones de Instalación
IMPORTANT :
VEUILLEZ LIRE L'ENSEMBLE
DES INSTRUCTIONS AVANT DE
COMMENCER L'INSTALLATION.
Les systèmes électriques Legrand sont
conformes au Code National de l'électricité
(National Electrical Code) ou aux codes
locaux en vigueur et doivent être mis à la terre
conformément à ces codes.
Tous les produits électriques peuvent présenter
un risque d'électrocution ou d'incendie s'ils ne
sont pas installés ou utilisés correctement. Les
produits électriques Legrand peuvent porter la
marque d'un laboratoire reconnu et doivent être
installés conformément au Code national de
l'électricité et/ou aux codes locaux en vigueur.
®
IMPORTANTE:
LEA TODAS LAS INSTRUCCIONES
ANTES DE COMENZAR LA
INSTALACIÓN.
Los sistemas eléctricos Legrand cumplen con
los requisitos del Código Eléctrico Nacional
(National Electrical Code, NEC) actual o con los
códigos impuestos por las autoridades locales y
deben conectarse a tierra consecuentemente.
Todos los productos eléctricos pueden
presentar un riesgo de descarga o incendio
si se los instala o utiliza incorrectamente. Los
productos eléctricos Legrand pueden llevar la
marca de un laboratorio de pruebas reconocido
a nivel nacional y se deben instalar conforme al
código local en vigencia o al Código Eléctrico
Nacional.
loading

Sommaire des Matières pour LEGRAND WIREMOLD RFB Serie

  • Page 1 DES INSTRUCTIONS AVANT DE ANTES DE COMENZAR LA BEGINNING INSTALLATION COMMENCER L'INSTALLATION. INSTALACIÓN. Legrand electrical systems conform to and Les systèmes électriques Legrand sont Los sistemas eléctricos Legrand cumplen con should be properly grounded in compliance with conformes au Code National de l'électricité...
  • Page 2 WARNING: Floor boxes must not be AVERTISSEMENT : Les boîtes de ADVERTENCIA: Las cajas de piso no allowed to be submerged in standing sol ne doivent pas être immergées se deben sumergir en agua estancada water between the rough-in and dans l'eau stagnante entre la phase entre la fase de preparación y activation phase, as this may result in...
  • Page 3 Knockouts Nocauts Volume Volume Each Wiring Each Corner Compartment (not for devices) Corner Compartments (not for devices) Volume Volume chaque Min. Pour Min. Pour Side Compartments End Compartments de chaque compartiment de Compartiments de Catalog Number (with collar) (without collar) compartiment de coin (Pas pour les coins (pas pour les...
  • Page 4 BARRIER INSTALLATION INSTALLATION DE LA BARRIÈRE INSTALACIÓN DE LA BARRERA DE PROTECCIÓN Position barriers as required for separation of services. Barriers may be positioned on either side of any compartment. Barrier installation is recommendation prior to concrete pour. Positionnez les barrières selon les besoins pour la séparation des services. Les barrières peuvent être placées de chaque côté de tout compartiment.
  • Page 5 Remove the (4) #10-32 flat head screws and lift off the top plate and inner shell from the floorbox base. Retirez les (4) vis à tête plate n° 10-32 et soulevez la plaque supérieure et la coque intérieure de la base du boitier de plancher.
  • Page 6 Leveling using ½ inch EMT and Adjust height and level using one of the following inverted leveling screws applicable methods: Mise à niveau à l'aide de vis de mise à niveau EMT de ½ pouce et de vis • Leveling screws provided inversées •...
  • Page 7 CONCRETE POUR COULÉE DU BÉTON VERTIDO DE HORMIGÓN Screed flush with disposable plate. Mettez-la au même niveau que la Igualar a ras con la placa desechable. plaque jetable. Note minimum required pour depths based Tenga en cuenta las profundidades de vertido on floorbox height, options, and future floor mínimas requeridas según la altura de la caja Notez les profondeurs d'écoulement minimales...
  • Page 8 FLOOR COVERING REVÊTEMENT DE SOL RECUBRIMIENTO DE SUELO - BARE CONCRETE – BÉTON NU - HORMIGÓN A LA VISTA Cat. Nos. RFBA10C55 (circular cover) N° de cat. RFBA10C55 (couvercle Caja de piso ref. cat. RFBA10C55 floorbox. circulaire). (cubierta circular) de 3/8". •...
  • Page 9 DEEP POUR PROFONDEUR DE COULÉE VERTIDO PROFUNDO (UP TO 4 INCHES [102 MM]) (JUSQU’À 4 POUCES [102 MM]) (HASTA 4 PULGADAS [102 MM]) Cat. No. RFBA10R55 floorboxes Boitier de plancher Cat. No. Caja de piso Ref. de cat. RFBA10R55 – Attach extension ring, Cat. No. RFBA10R55 –...
  • Page 10 DEVICE PLATE INSTALLATION INSTALLATION DE LA PLAQUE DU DISPOSITIF INSTALACIÓN DE LA PLACA DE DISPOSITIVOS Secure receptacle or data connector to device plate. Fixez le réceptacle ou le connecteur de données à la plaque du dispositif. Asegure la toma o el conector de datos en la placa de dispositivos Insert lower end of device plate into inner shell.
  • Page 11 COMBINATION DEVICE PLATE ADAPTER INSTALLATION INSTALLATION DE L’ADAPTATEUR DE PLAQUE DU DISPOSITIF COMBINÉ INSTALACIÓN DEL ADAPTADOR DE PLACA DE DISPOSITIVOS DE COMBINACIÓN For use with listed NEMA 2 and 3-gang device plates Pour une utilisation avec les plaques certifiées du dispositif NEMA 2 et 3-gang Para usar con las placas de dispositivos de 2 y 3 bandas NEMA Grip the vertical rib separating adjacent compartments of the inner shell with pliers and twist.
  • Page 12 RFBA10C55. No: 1025916 1022 860.233.6251 1.877.BY.LEGRAND www.legrand.us © Copyright 2022 Legrand All Rights Reserved. www.legrand.ca © Copyright 2022 Tous droits réservés Legrand. © Copyright 2022 Legrand Todos los derechos reservados.