Makita DTM40 Manuel D'instruction page 7

Indication lamp
1
► 1. Indication lamp
• When the remaining battery capacity gets low, the
indication lamp blinks.
• When the remaining battery capacity gets much
lower, the tool stops during operation and the
indication lamp lights up about 10 seconds.
At this time, remove the battery cartridge from the tool
and charge it.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing or removing application
tool (optional accessory)
WARNING:
• Do not install application tool upside down.
Installing application tool upside down may
damage the tool and cause serious personal
injury.
• Install attachment tool in the correct direction
according to your work. Application tool can be
installed at an angle of every 30 degree.
1
2
3
► 1. Application tool installation bolt 2. Holes in the
application tool 3. Protrusions of the tool flange
1
► 1. Application tool installation bolt 2. Hex wrench
3. Tighten
Put an application tool (optional accessory) on the tool
flange so that the protrusions of the tool flange fit in the
holes in the application tool and secure the application
tool by tightening the bolt firmly with the hex wrench.
When using sanding application tool, mount the appli-
cation tool on the sanding pad so that it matches the
sanding pad direction.
The sanding pad has a hook and loop type fitting sys-
tem which allows easy and rapid fitting of a sanding
paper.
As sanding papers have holes for dust extraction,
mount a sanding paper so that the holes in a sanding
paper match those in the sanding pad.
To remove a sanding paper, raise its end and peel it off.
Loosen and remove the application tool installation bolt
using a hex wrench and then take off the application
tool.
1
2
3
4
► 1. Application tool installation bolt 2. Holes in the
application tool 3. Adapter (required for some appli-
cation tools) 4. Protrusions of the tool flange
When using application tools with a different type of
installation section, use a correct adapter (optional
accessory).
7 ENGLISH
2
3