Power Switch - Sony HR Trinitron PVM-20M7MDE Mode D'emploi

English
WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
Dangerously high voltages are present
inside the unit.
Do not open the cabinet. Refer servicing
to qualified personnel only.
In the event of a malfunction or when maintenance is
necessary, consult an authorized Sony dealer.

Power Switch

The power switch is a functional switch only. To
isolate the set from the mains supply remove the
mains plug from the wall socket.
For customers in the United Kingdom
WARNING
THIS APPARATUS MUST BE EARTHED
IMPORTANT
The wires in this mains lead are coloured in
accordance with the following code:
Green-and-yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
markings identifying the terminals in your plug proceed
as follows:
The wire which is coloured green-and-yellow must be
connected to the terminal in the plug which is marked
by the letter E or by the safety earth symbol Y or
coloured green or green-and-yellow.
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected
to the terminal which is marked with the letter L or
coloured red.
Ensure that your equipment is connected correctly - If
you are in any doubt consult a qualified electrician.
2
Important safeguards/notices for use in the
medical environments
1. All the equipments connected to this unit shall be
certified according to Standard IEC601-1, IEC950,
IEC65 or other IEC/ISO Standards applicable to
the equipments.
2. When this unit is used together with other
equipment in the patient area*, the equipment shall
be either powered by an isolation transformer or
connected via an additional protective earth
terminal to system ground unless it is certified
according to Standard IEC601-1 and IEC601-1-1.
* Patient Area
3. The leakage current could increase when
connected to other equipment.
4. The operator should take precautions to avoid
touching the rear panel input and output circuitry
and the patient at the same time.
5. Model PVM-20M7MDE is a video monitor intended
for use in a medical environment to display video
pictures from cameras or other video system.
This unit contains substances which can pollute the
environment if disposed carelessly. Please contact
our nearest representative office or your local
environmental office in case of disposal of this unit.
ATTENTION:
Picture distortion may occur if this monitor is
positioned in close proximity to any equipment
emitting electromagnetic radiation.