Automatic Start; Manual Start - Fuxtec Fx-Rb224 Manuel D'utilisation

•
Press the "SET" button until the M² symbol lights up.
•
Use the arrow buttons ("HOME" and "START") to enter the size of the area to be mowed in
increments of 50 m² and confirm with "OK".

Automatic start

•
Press "SET"
•
Enter your 4-digit security code / factory code (0000) and confirm with "OK"
•
Press "Confirm" until the area to be mowed is set in m² and confirm with "OK".
Setting the automatic start time
•
Press "SET" until the hourglass symbol lights up.
•
Use the arrow buttons ("HOME" and "START") to press the desired start time and confirm with
"OK".
•
If the 4 digits 0000 light up constantly, the start time is set.
•
Press "START".
Note: When the appliance has finished its work cycle, it automatically restarts 48 hours later at the

Manual start

•
Press "SET"
•
Enter your 4-digit security code/factory code (0000) and confirm with "OK".
•
Press "START"
Setting the security code
•
The factory default security code is: 0000. If you want to keep this code, proceed as described
above.
•
If you want to change the code, first enter the factory code 0000 + START.
•
The machine leaves the docking station and starts to run.
•
After a few metres, press STOP and the error code E1 appears on the display.
•
Press START and hold the START button for 10 seconds until the code U133 appears on the
display.
•
Press SET. The lock symbol (picture) flashes. Confirm the factory code 0000 in succession with
OK until the digits 0000 light up constantly.
•
Press SET again and the lock symbol flashes.
•
Now enter your personalised 4-digit security code and confirm with OK.
•
Your personal security code is now set and lights up constantly.
Manual_FX-RB224_Int24_rev1
same time.
41