Sharp MultiSync E224F Manuel D'installation page 11

Handling the power cord.
The monitor should be installed close to an easily accessible power outlet.
REQUIRED
When connecting the power cord to the product's AC input terminal, make sure the connector is
fully and firmly inserted.
An incomplete connection of the power cord may cause overheating of the plug; it allows dust to
get on the plug connection, which can lead to a fire. Touching the pins of a partially inserted plug
REQUIRED
may lead to an electric shock.
Handling the power cord by following below to avoid fire or electric shock.
• When connecting or disconnecting the power cord, pull the power cord out by holding onto its
plug.
• Unplug the power cord from the power outlet before cleaning the product or when not planning to
use the product for an extended time.
REQUIRED
• When the power cord or plug is hot or damaged, unplug the power cord from the power outlet,
and contact a qualified service person.
Regularly dust off the power cord by using a soft dry cloth.
REQUIRED
Before moving the product, make sure the product power is off, then unplug the power cord
from the power outlet and check that all cables connecting the product to other devices are
disconnected.
REQUIRED
Do not use the power cord with a power tap.
Adding an extension cord may lead to fire as a result of overheating.
PROHIBITED
Please confirm the distribution system in building installation shall provide the circuit breaker rated
120/240 V, 20 A (maximum).
REQUIRED
Do not bind the power cord.
It may trap heat and cause a fire.
PROHIBITED
Do not climb on the table where the product is installed. Do not install the product on a wheeled
table if the wheels on the table have not been properly locked. The product may fall, causing
damage to the product or personal injury.
PROHIBITED
Installation, removal, and adjustment of the stand.
• Handle with care when pulling the stand as it might pinch your fingers.
• In the case of a stand to be fixed with screws, please securely hold the monitor stand while
removing the screws to prevent the monitor stand from falling. It may case personal injury.
• Please hold the base securely when detaching it from the stand to prevent it from falling. It may
cause personal injury.
• Before rotating the screen, disconnect the power cord and all cables from the product.
REQUIRED
Otherwise, the power cord or cables might pull with excessive force and cause personal injury or
damage to the product.
• When rotating the screen, slide it to the highest level and set it to the maximum tilt.
Otherwise, it could cause personal injury or knock the screen on the desk.
CAUTION
English-6
EN