Insignia NS-15LCD Guide De L'utilisateur page 24

NS-15LCD 15-inch TV - combined.fm Page 23 Wednesday, March 29, 2006 5:16 PM
NS-15LCD 15" LCD TV
Setting up in Component mode
To set up in Component mode:
1 Press MENU. The main menu opens.
2 Press CH
the Window menu. The Window menu opens.
3 Press CH
adjust the setting.
Note Auto Config is not available in Component mode.
Setting up in VGA mode
The native resolution of this TV is 1024 × 768, so your computer
should be set to this resolution when you connect it to the TV.
This TV only supports refresh frequencies of up to 60 Hz, so set your
computer accordingly. If you set it higher, the screen may flicker.
To set up in VGA mode:
1 MENU. The main menu opens.
2 Press CH
the Window menu. The Window menu opens.
3 Press CH
/ to adjust the setting.
Note The Phase and Clock settings should be adjusted until you get a
good picture.
If you experience problems when adjusting the settings, set Auto
Config to Off, then reset it to On. The TV resumes its original
settings.
/ to select Window, then press VOL
Auto Config
Off
Phase
80
Clock
60
H. Position
90
V. Position
80
Temp
Red
80
Green
80
Blue
60
/ to select the setting, then press VOL
/ to select Window, then press VOL
/ to select the item you want to set, then press VOL
www.insignia-products.com
/ to open
/ to
/ to open
23