Forced Operation; Test Operation; Auto Restart Function - Lg 2-Knudb09 Manuel Du Propriétaire

30
OPERATION

Forced Operation

Forced operation is used when the remote controller
can't be used.
• The operation will be started if the Forced Operation
button is pressed.
Type 1
Forced Operation Button

Test Operation

During the TEST OPERATION, the unit operates in
cooling mode at high speed fan, regardless of room
temperature, and resets after 18 minutes. During test
operation, if the remote controller signal is received, the
unit can be set by the remote controller. If you want to
use this operation, Press and hold the ON/OFF button
for 3 ~ 5 seconds, then the buzzer sound 1 will 'beep'. If
you want to stop the operation, re-press the button.

Auto Restart Function

This function is useful in the case of power failure. When
power regains after a failure this feature restores the
previous operating condition and the air conditioner will
run in the same settings.
NOTE
• This feature is enabled by the factory default settings,
but you can disable it by pressing and holding the ON/
OFF button for 6 seconds. The unit will beep twice
and the lamp will blink 8 times.
• To enable it, press the button again for 6 seconds.
The unit will beep twice and the blue lamp will blink 4
times.