Installing The Batteries To The Remote; Connect Power & Antenna/Cable/Satellite; Switching On/Off; First Time Installation - Telefunken L19H970I3 Mode D'emploi

Installing the Batteries to the Remote

1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable/
Satellite
IMPORTANT: The TV set is designed to operate on 12
V DC. For this, an adaptor is used which gives 12 V
voltage. Connect this adaptor to a system that supplies
110-240V AC, 50/60Hz. After unpacking, allow the TV
set to reach the ambient room temperature before you
connect the set to the mains.
To POWER
INPUT DC 12 V
terminal
AC adapter

Switching On/Off

Switching the TV On
Connect the power cord to the 110-240V AC,
50/60Hz.
Satellite
Aerial or Cable
DiSEqC
Switch
English - 38 -
To switch the TV on from standby mode:
Press the " " button and the TV will switch to
standby mode. Then the standby LED lights up.
To switch on the TV from standby mode either:
a. Press the " " button, CH ^ / v or a numeric button
on the remote control.
b. Press the middle of the "
By either method the TV will switch on.
Switching the TV Off
Press the " " button on the remote control or press
the standby " " button, so the TV will switch to
standby mode.
To turn off the TV completely, remove the power
cord plug from the mains power socket.
Note: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search, Over
Air Download or Timer is active. The LED can also blink when
you switch on the TV from standby mode.

First Time Installation

When turned on for the first time, the "language
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Press the " " or "
required language, press OK button to select. "First
Time Installation" appears. Use "
set the required country, and press "
select Search Type (optional).
Use " " or " " to set the desired search type. Available
search types are Digital and analog, digital only and
analog only.
When set, press "
Use " " or " " to select the desired Teletext Language.
Next, select Scan Encrypted and set as Yes if you
want to scan coded stations.
" button on the TV.
" button to highlight the
" or " " button to
" button to
" to select Teletext Language.