Remote Control - Sharp 32Gf2 Guide De Démarrage Rapide

6
What is included in the box
Supply of this TV includes following parts:
• 1x TV
• 1x Remote control
• 1x Power cord
Attaching the Stand
Please follow the instructions on last page of this user manual.
Wall mounting the TV
Install the wall mounting bracket to the television as advised by the
bracket manufacturer.
Connections
Connecting external devices - see the last page in this IM.
Getting started - initial set up
1. If rubber parts, foam parts or tape are attached to the TV frame, please
remove them gently.
2. Using the antenna cable (not supplied), connect the TV to the antenna
wall socket.
3. For connecting to the Internet with a wired connection connect a
Cat 5/Ethernet cable (not included) from the TV to your broadband
modem/router.
4. Insert the supplied batteries into the Remote control.
5.
Connect the power cable to the Electrical outlet.
6. Then press Standby button to power on the TV.
7. After turning the TV on, you will be welcomed by the First Time
Installation menu.
8. Pair your voice remote following the on-screen instructions. Press and
hold the (microphone) button on the remote until the instructions
on the TV screen change to the next step.
9. Please select a language for the TV menu.
10. Please set desired settings in remaining screens of the First installation
menu.
TV control button
The TV is equipped with a single control button located at the bottom of
the LED light. Press the button to turn the TV on/off.
• 1x TV stand installation packet
• 1x Quick Start Guide
• 2x AAA batteries
Choosing Mode Input/Source
To switch between the different input/connections.
Using the buttons on the remote control:
1. Press [SOURCE] - The source menu will appear. Alternatively,
you can press and hold the
of inputs.
2. Press [▲] or [▼] to select the input you require.
3. Press [OK].
TV Menu navigation
Use the (▲/▼/◄/►) buttons to focus on the desired item.
Press the OK button to select the item currently in focus.
Press the (back) button to go back one step in the menu.
Press the EXIT button to leave menu.
Press the (home) button to enter the TV Home menu.
Electronic instruction manual
To access more useful information directly from your TV, you can launch
the online manual by following these steps:
1. Press the
(home) button on your remote.
2. Using the cursor, navigate downwards to "Your apps".
3. From the list of apps, locate and select "Smart Portal".
NOTE: Please ensure that your TV is connected to the
internet in order to use this electronic manual.

Remote control

Your remote is equipped with a microphone, allowing you to control the
TV with your voice. However, to enable voice control, the remote must be
paired with the TV via Bluetooth. Pairing is done during the initial setup.
If your remote loses its pairing with the TV for any reason, you can
manually pair it through the settings menu by following these steps:
1. Press the (home) button, then select
2. The Quick settings menu appears. Keep the cursor on the Settings
symbol and press the OK button again to enter the Settings menu.
3. Then select [Remotes & Accessories] > [Pair accessory].
4.
Follow the on-screen instructions to pair the remote control with the
TV.
5. The name of your remote will appear on the TV Screen. Press OK to
confirm the pairing.
(TV guide) button to display the list
[Settings] and press [OK].