Headboard Brackets (Not Included) - Sealy Easy Twin 82001-38.74-040 Manuel Du Propriétaire

headboard bracket installation guide (optional)
Headboard Brackets are an optional accessory and are not included.
A 9/16" (14mm) socket wrench and 1/2" (13mm) crescent wrench are necessary to complete installation.
STEP 1
a.) Align the hole in the bracket to the brass sleeve into which the leg
threads. Hold the bracket in place and screw the leg into the base
until it is snug. DO NOT OVERTIGHTEN. Too much force may cause
the leg to spin freely.
b.) Align the tab with the hole in the frame (located towards the foot of
the base) and use a short bolt and nut to secure the bracket. Make
sure the bolt is tight.
STEP 2
Attach the plastic spacer and T-Bracket.
a.) Measure the distance between the mounting holes on the
headboard and install the spacer and attachment plate to
accommodate the headboard.
b.) To install the plastic spacer and attachment plate, you will need
(2) long bolts and (2) nuts. Place the spacer and attachment plate
in the desired location and slip the bolts through the holes with
the head of the bolt facing outward. Position the bolts diagonally
on the spacer. Use the 9/16" (14mm) socket wrench and 1/2"
(13mm) crescent wrench to tighten the bolts.
STEP 3
You may now connect your headboard to the attachment plates using the
remaining short bolts and nuts to secure it to the brackets. The heads of
the bolts will face outward. Use the 9/16" (14mm) socket wrench and 1/2"
(13mm) crescent wrench to tighten the bolts.
13