Syncing Two Bases - Sealy Easy Twin 82001-38.74-040 Manuel Du Propriétaire

syncing two bases (optional)
A Sync Cord is included with the base. Not available on Queen, Full or Full-Long size bases.
The Sync Cord connects the two control boxes to a single remote for the synchronization of two bases.
STEP 1
Unplug bases from power source.
STEP 2
Disconnect the Battery Backup Box cable from each Control Box or splitter
cable. Make note where the cable was plugged in.
STEP 3
Connect the male end of each Sync Cord to Control Box or splitter cable.
Insert it into the same port that you disconnected the Battery Backup
Box from in Step 2.
STEP 4
Connect each Battery Backup Box male connection to the sync cord
female connection (Refer to illustration at right).
STEP 5
Plug bases back into the power source.
STEP 6
Check to ensure all cords are securely attached. Both remotes will now
operate both bases simultaneously.
The system is now linked. Buttons pressed on either remote
will control both bases simultaneously.
12
Sync Cord
Control Box 1
Battery
Backup Box 1
PERFORMANCE NOTES
If bases become mismatched, pressing the FLAT button will re-sync the
mechanical positions.
Control Box 2
Battery
Backup Box 2