Allen + Roth L-GZ604PCO-F Mode D'emploi page 8

ASSEMBLY INSTRUCTIONS
2. Connect the left long decorative groove (C1) and the
right long decorative groove (C2) to a decorative groove
connector (G) using four M6 x 15 mm bolts (AA) and M6
flat washers (BB). Tighten with Phillips screwdriver.
Repeat this step for the remaining left long decorative
groove (C1), right long decorative groove (C2), and another
decorative groove connector (G). Then repeat this step
for the two left short decorative grooves (D1), right short
decorative grooves (D2), and remaining decorative groove
connectors (G).
Hardware Used
M6 x 15 mm Bolt
AA
M6 Flat Washer
BB
3. Insert 7 plastic hooks (U) inside each left long mosquito
netting tube (K1) and 6 plastic hooks (U) inside each left
short mosquito netting tube (K3). Repeat for each right long
mosquito netting tube (K2) and each right short mosquito
netting tube (K4).
4. Attach the right short mosquito netting tube (K4) to the
right short decorative groove (D2) using 5 M6 x 15 mm
bolts (AA) and M6 flat washers (BB) for each. Repeat this
step for the left short mosquito netting tube (K3) and left
short decorative groove (D1).
Attach the right long mosquito netting tube (K2) to the
right long decorative groove (C2) using 6 M6 x 15 mm
bolts (AA)and M6 flat washers (BB) for each. Repeat
for the left long mosquito netting tube (K1) and left long
decorative groove (C1). Tighten with Phillips screwdriver.
Note: Ensure there is a space/hole open in the middle of
short grooves to install the middle beam (F) later on.
Hardware Used
M6 x 15 mm Bolt
AA
M6 Flat Washer
BB
x 16
x 16
x 44
x 44
8
2
C2
BB
AA
BB
AA
3
K1
U
4 4
BB
AA
BB K4
AA
BB
AA
AA
Lowes.com/allenandroth
G
C1
D2
K4
D1
K3
D2
BB
BB
AA