Allen + Roth L-GZ604PCO-F Mode D'emploi page 12

ASSEMBLY INSTRUCTIONS
13. Attach the top of oblique beams (E) to the underside
of roof connector (O) using M6 x 15 mm bolts (AA) and
M6 flat washers (BB). Tighten with Phillips screwdriver.
Hardware Used
M6 x 15 mm Bolt
AA
M6 Flat Washer
BB
14. Attach post connectors (Q) to the top of each post (A).
Then, with the assistance of another person, lift the assembly
from step 13 and insert an M6 x 20 mm bolt (GG) through
a M6 flat washer (BB), then through the bottom of oblique
beam (E), post (A) and post connector (Q). Tighten with
Phillips screwdriver.
Repeat for each corner.
Hardware Used
M6 x 20 mm Bolt
GG
M6 Flat Washer
BB
15. Attach the top of middle beams (F) to the underside
of roof connector (O) using M6 x 15 mm bolts (AA) and
M6 flat washers (BB). Tighten with Phillips screwdriver.
Hardware Used
M6 x 15 mm Bolt
AA
M6 Flat Washer
BB
13
x 4
x 4
14
x 4
x 4
15
x 6
x 6
12
E
E
GG BB
A
O
BB
AA
F
Lowes.com/allenandroth
O
BB
AA
Q
E