Publicité
Under no circumstances should you hold
your hands between the dirt receptacle and
filter ring or allow them to come close to the
lifting mechanism while locking it.
Lock the dirt receptacle by operating the
bow handle with both hands.
8. Insert the dirt receptacle into the device
in reverse order.
Transport
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transport and storage.
1. When transporting in vehicles, secure
the device against slipping and tipping
over according to the applicable guide-
lines.
Storage
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
storage.
1. Store the device indoors only.
Care and service
DANGER
Risk of injury due to inadvertently start-
ing up device and also due to electric
shock.
Switch off the device immediately and un-
plug the mains plug before performing
work.
Inspection and maintenance work
Have the device regularly inspected ac-
cording to the respective national accident
prevention regulations. Maintenance work
as specified by the manufacturer must be
performed by a technically qualified person
at the specified regular intervals and in ac-
cordance with the applicable regulations
and safety requirements. Work on electrical
components may only be performed by a
qualified electrician. Please contact a
KÄRCHER branch office if you have any
questions.
14
Maintenance intervals / user
No periodic maintenance intervals are
specified for this device. The following
maintenance is to be performed as neces-
sary:
● Wash the filter.
● Change the filter.
● Replace the filter.
Wash the filter
ATTENTION
Use of detergents or bleach
Damage to the filter.
Clean the filter with water only. Only fit the
filter in the device when it is completely dry.
The star folded filter can be washed out un-
der running water.
1. Always flush the star folded filter from
the inside to the outside so that no re-
maining particles impair the filter perfor-
mance.
Changing/replacing the filter
Note
2 persons are needed to remove the suc-
tion head.
1. Switch off the device.
2. Pull out the mains plug.
3. Unlock and remove the suction head.
4. Unlock the remove the spacer.
5. Remove the star pleated filter.
6. Check the sealing ring for damage.
7. Insert the new star pleated filter:
a Pull the new star pleated filter over the
filter vibrator on the spacer such that
the vibrating elements are aligned
centrally in the filter bags.
b Place the spacer with star pleated fil-
ter and filter vibrator on the filter ring.
c Lock the spacer.
8. Fit the suction head and lock.
Troubleshooting guide
DANGER
Unintentional start-up of the device /
electric shock
Unintentional start-up of the suction motor
can cause injuries. Voltage present on
electrical parts can cause an electric shock.
English
maintenance
Publicité
