Makita 6904VH Manuel D'instruction page 5

For 6905H
1
002323
This tool has a reversing switch to change the rotational
direction. Press the right side of the switch for clockwise
(forward) rotation or the left side for counterclockwise
(reverse) rotation.
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
Speed change
For 6904VH only
002329
To change the speed, first switch off the tool and then
slide the speed change lever fully to the "H" side (lower
side) for high speed or to the "L" side (upper side) for low
speed. Before starting operation, ensure that the speed
change lever is slid fully to the desired side. Select the
speed optimum for your job.
CAUTION:
Do not use the speed change lever while the tool is
•
running. The tool may be damaged.
1. Reversing
switch
1. Speed change
lever
1
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Selecting correct socket
Always use the correct size socket for bolts and nuts. An
incorrect size socket will result in inaccurate and
inconsistent fastening torque and/or damage to the bolt
or nut.
Installing or removing socket
1
2
002335
To install the socket, push it onto the anvil of the tool until
it locks into place.
To remove the socket, simply pull it off.
OPERATION
007444
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
5
1. Socket
2. Anvil