General Safety And Accident Prevention Regulations - Vicon ANDEX 773 Notice De Montage

1.3 General safety and accident
prevention regulations
1. The allocation of responsibilty for the various
tasks on the machine must be clearly defined
and complied with. There may be no
uncertainties regarding authority, as these
could endanger the safety of the operator.
2. Before operation, make yourself familiar with
all elements and controls of the machine, as
well as with their function.
3. Any work on the machine should be carried
out using suitable tools and apparatus in
perfect condition.
4. You may not use any parts (spares,
accessories, lubricants etc.) other than those
complying with or exceeding the manufac-
turer's requirements and you must use them
according to the instructions (including the
torque values indicated).
A part complies with the manufacturer's
requirements when either genuine or
approved by the manufacturer.
5. The operator's clothing should be close fitting!
Always wear robust footwear and the
prescribed protective equipment!
6. When mounting the implement, support it
carefully and secure it!
7. Special care has to be taken when working
on energy storers such as springs and
hydraulic or compressed air aggregates.
8. Dispose of used oil, grease and filters
according to the regulations!
9. Make sure that the protective devices are
mounted according to the regulations and put
into safety position.
10.All operating devices such as ropes, chains,
rods, etc. which act on remote-controlled
implement elements have to be installed in such
a way that no unintentional movement is
possible in any transport or operating positions!
11.Do not leave the engine on within closed
spaces!
12.Caution when working on implement elements
operated by additional driving systems and
any other flexible parts (e.g. hydraulics). Risk
of squeezing and shearing!
13.Pay careful attention to the markings on parts
with two possible connections or wherever
sides could be confused.
14.Always disconnect the power suppy before
carrying out any work on the electrical system!
15.The generator and battery cables should be
disconnected before any electrical welding
is carried out on the tractor or the mounted
implement!
Observe the legend and torque values listed in
the table or specifically mentioned in the mounting
instruction text.
Directions quoted ("right", "left", "in front",
"behind") are always taken as being in the
direction of travel.
The direction of rotation is defined as follows:
Direction of rotation right = clockwise
Direction of rotation left = anticlockwise
Rotations around a vertical axis, taken from
top to bottom
Rotations around a horizontal axis, at a right
angle to the direction of travel, taken from left
to right
Rotations of nuts, bolts etc. are always taken
from the side from which they are operated
EN
5