Epson WorkForce 435 Guide Rapide page 25

Masquer les pouces Voir aussi pour WorkForce 435:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6.
Remove the yellow tape from the bottom of the ink cartridge.
Caution: Do not remove any other labels or seals, or ink will leak. Do not touch the
green chip on the front of the cartridge. This can damage the ink cartridge.
7.
Insert the new ink cartridge into the holder and push it down until it clicks into place.
8.
Once you replace all the cartridges that need replacing, close the cartridge cover and
push it down until it clicks into place.
9.
Close the scanner.
10. Press
to begin charging the ink. This takes about 2 1/2 minutes. When you see a
OK
completion message on the LCD screen, ink charging is finished.
Note: Never turn off the product while ink is charging or you'll waste ink. If you see
an ink replacement message on the LCD screen, press
cartridges securely. Then press
cartridge, you cannot reinstall and use the cartridge.
again. If you remove a low or expended ink
OK
and press down all the
OK
Replacing Ink Cartridges
25

Publicité

Table des Matières
loading

Table des Matières