VEVOR FR25049L-72MBK Mode D'emploi page 9

1. Loosen the two fan motor assembly coupling set screws from the fan
motor assembly coupling.
2. Remove the Cross pin and R pin from the down rod .
3. Remove the hanger ball from the down rod by loosening the hanger ball
set screw, and removing the3Bolt, then sliding the hanger ball off the down
rod.
4. Carefully feed the fan wires from the fan motor assembly up through the
down rod.
5. Thread the down rod into the fan motor assembly coupling.
6. Align the holes and reattach the Cross pin and the R pin .Tighten the
setscrews.
7. Slip the coupling cover, canopy cover and canopy onto the down rod.
8. Carefully reinstall the hanger ball onto the down rod, and ensure that
the Bolt is in the correct position, the hanger ball set screws are tight, and
the wires are not twisted.
c: Hanging the fan
WARNING: To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
1. Install hanger ball at the end of downrod into mounting bracket opening.
Align (engage) slot on ball with tab on mounting bracket.
Warning: Failure to align slot on ball with tab may result in serious
injury.
2.Make wire connection between the Fan and power supply, (Please refer
to the section "WIRE CONNECTION')
8