VEVOR FR25049L-72MBK Mode D'emploi page 17

TROUBLE SHOOTING:
FAN WILL NOT START:
1. Check all fuses or circuit breakers.Replace if missing.
2. Turn off electrical power and check all wire connections to fan and in
switch housing.
3. Battery was used up or incorrect polarity in remote control.
FAN IS NOISY:
1. Always allow a few days "break in" time for any new fan at medium or
high speed. Try to diagnose the exact location of the noise by listening
carefully from several sides (blades, motor, light kits, etc.). Fan noise can
come from a light kit.
2. Make sure all screws in the fan assembly and light kit are tight and
properly threaded. If not, back out and retighten. Tighten these screws at
least once a year because they may loosen slowly over time and cause a
clicking noise.
3. Make sure mounting bracket is installed snugly to junction box.
4. Make sure wire nuts in switch housing or canopy are not rattling against
each other or against wall of housing. Wrap with electrical tape if
necessary.
5. Make sure the canopy is not touching the ceiling.
6. Assure that the screws fastening blade arm to motor are tight and the
lock washers provided for that purpose have been used.
FAN TURNS BUT DOES NOT MOVE MUCH AIR:
1. The fan may be running in reverse, so air is directed upward
2. The room may contain items that obstruct the air flow.
3. The fan may be too small for size of the room.
FAN SHAKES OR WOBBLES:
A small amount of movement is considered acceptable and should not be
considered a defect.Make sure mounting bracket is tight at junction
16