Publicité
ACTIVITIES
If you set up the default devices for any Activity on the remote (for
example a TV and STB for Watch TV) that Activity will be set up
automatically on the remote. If you would like to change to a different
combination, the procedure is as follows:
1.
2.
3.
The LED will blink twice and go out.
4.
To access the Activities, simply press the ACTIVITY key to scroll through
until the desired one is lit. You can return to controlling by device by
using the DEVICES key.
AV Shift
As the AV key is intended to select the input on your TV and most TVs
use a menu to select from a list of inputs, when the AV key is pressed
in an Activity, the Menu Up, Down, Left, Right and OK keys temporarily
control the TV. If the OK key is pressed, or no key is pressed for ten
seconds, these keys will revert to controlling the relevant device for the
Activity (e.g. STB in Watch TV Mode).
Power Macro
If you hold down the Power key for 2 seconds in any Activity, the
remote will send the Power function for each device contained within
that Activity. So for example, holding Power in the default setting for
Watch TV will turn both the TV and Set Top Box on or off.
Hereby, Universal Electronics BV declares that the radio equipment
type URC7956 is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available
http://www.oneforall.com/doc_smartcontrol
Hold down SETUP until the LED under the
device blinks twice.
The LED under the current mode key will
stay lit.
Use the ACTIVITY key to scroll through the
Activities until the one you want to set is
flashing.
Press the number of the combination you
want to set – e.g. 2
for TV + STB + AUD in Watch TV.
Radio Equipment Directive (RED)
at the following internet address:
11
Publicité
