Publicité
GETTING STARTED
Before the first operation
Remove all the packaging material. Leave the appliance upright for at least 4 hours
before inserting the power cord into the socket. This reduces the possibility of
malfunction due to improper handling during transport. Clean the inner surfaces
with lukewarm water and a soft cloth.
Before switching on
Make sure that the appliance is installed by a quali ed person in accordance
•
with the operating instructions.
•
After setting up the appliance, wait four hours before plugging it into the
power socket. This allows the refrigerant to be completely distributed in the
refrigerant circuit again.
•
Clean the outside of the appliance and the removable accessories with a mild
soap solution and water before rst use.
•
Clean the inside of the appliance with a solution of sodium bicarbonate and
water. Dry the inside of the appliance and the accessories properly after
cleaning.
You may notice a strange smell when switching on the appliance for the rst
•
time. This is normal and the smell disappears as soon as the appliance starts
to cool down.
During initial use
Note: When using the appliance for the rst time or when switching the
appliance on again after a long time, there may be a difference of a few degrees
between the temperature you have set and the temperature displayed on
the screen. This is normal. If the appliance has been on for a few hours, the
temperature will adjust.
When you switch on the appliance for the rst time, the unit's compressor
•
runs continuously until the appliance has cooled down.
•
The appliance door should be opened as seldom as possible during cooling.
•
If the appliance has been switched off or the power plug has been
disconnected from the mains socket, wait at least 5 minutes before switching
it on again or reconnecting the power plug to the mains socket.
EN
27
Publicité
