Programming/Deleting Transmitters - Selve Commeo Receive Garage Notice De Réglage

Putting into operation/setting radio reception
Note for settings under point 6.2.: The drive/receiver must be
selected for these settings with a transmitter in SELECT mode (sta-
tus LED slowly flashes orange). After the setting has been config-
ured, the drive/receiver is still selected (see point. 6).

6.2.1. Programming/deleting transmitters

To programme or delete a transmitter, select the required channel
and press the PROG button for 1 second. The status LED lights up
green to indicate that the transmitter has been programmed. If the
status LED lights up red, this indicates that the transmitter has been
deleted.
1 s
Status LED transmitter = green transmitter is
Status LED transmitter = red transmitter has
26
programmed
been deleted