Programming/Deleting Transmitters; Delete Transmitter Table In The Receiver - Selve commeo 297774 Mode D'emploi

EN
commeo initial operation/Setting
Note for settings under point 4.2.: The motor/receiver must be
selected for this setting with a transmitter in SELECT mode (Status
LED flashes slowly in orange). After completing the setting, the
motor/receiver is still selected (see point 4.).

4.2.2. Programming/deleting transmitters

To program or deprogram a transmitter, select the desired channel
and push the PROG button for 1 second. The status LED lights up
green to indicate that the transmitter has been programmed. A red
light means that the transmitter has been deprogrammed.
1 s

4.2.3. Delete transmitter table in the receiver

To delete the transmitter table in the receiver, push the PROG button
on the transmitter for 6 seconds. All transmitters programmed in the
receiver are deleted. T he programmed receiver has been cancelled in
the transmitter.
Note: This causes an error message if there are any more
programmed receivers!
I f this receiver in operating mode moves over a transmitter
which is still programmed, the transmitter will no longer
6 s
receive a response and will acknowledge this with an error
message.
Status LED transmitter = g reen  t ransmitter
Status LED transmitter = r ed  t ransmitter
38
programmed
d eleted