Selve commeo 297774 Mode D'emploi page 35

commeo initial operation/Setting
If multiple receivers have been found, the selected receiver can be
changed by pressing the SELECT button for 1 second. The next
receiver will perform a brief confirmation run. Only one receiver can
be selected at one time for moving, setting and programming.
SELECT mode
Receiver X
Exit SELECT mode
T o exit SELECT mode (the status LED will flash slowly in
orange), press the SELECT button for 3 seconds.
3 s
Status LED indicator on the transmitter for the various operating
modes
Transmitter mode
Operating mode
SELECT mode
CONFIGURATION mode
(only for authorised qualified personnel),
see 4.2.5.
Power interruption/
programmed transmitter
Receiver 1
SELECT 1 s
SELECT 1 s
Receiver 3
SELECT 3 s
Receiver 2
Indicator on status LED
Lights up when a button is
pressed
Flashes slowly in orange
Flashes slowly in green or red
35
EN
SELECT 1 s
SELECT 1 s
EN