Maintenance; Repair; Storage; Transportation - Parkside Pasa 20-Li D3 Mode D'emploi

In particular, clean the air vents after
o
every use with a cloth and soft brush .
The vents must always be clear .
˜ Maintenance
Before and after each use: Check
o
the product and accessories (e .g .
saw blades) for wear and damage . If
required, replace worn or damaged
accessories . Observe the technical
requirements (see "Technical data") .
Check covers and safety devices
o
for sound condition and correct
installation . If that is not the case,
have them replaced by an expert .
Replace the saw blade
o
becomes blunt, bent or damaged in
any other way .
˜ Repair
This product does not contain any
o
parts that can be repaired by the
user .
Contact an authorised service centre
o
or a similarly qualified person to have
the product checked and repaired .
˜ Storage
Clean the product as described
o
above .
Store the product and its accessories
o
in a dark, dry, frost-free, well-
ventilated place .
Always store the product in a place
o
that is inaccessible to children .
The ideal temperature for a long term
o
storage (longer than 3 months) is
between +20 °C and +26 °C.
Store the product in its carrying
o
case .
18 GB/IE/NI
Battery pack
o
o
˜ Transportation
o
if it
6 ] [
o
o
˜ Disposal
The packaging is made entirely of
recyclable materials, which you may
dispose of at local recycling facilities .
Product:
Before storing for extended periods:
Only store the battery pack
partially charged . The battery pack
should be charged at 40 to 60 % (red
and orange charging level LEDs
light up) .
When storing for extended periods:
Check the charging level of the
battery pack about every
[ 3 ]
3 months. Recharge the battery
pack, if necessary .
Transport the product in its carrying
case .
Protect the product from any heavy
impact or strong vibrations which
may occur during transportation in
vehicles .
Secure the product to prevent it from
slipping or falling over .
Observe the marking of the
packaging materials for waste
separation, which are marked
with abbreviations (a) and
numbers (b) with following
meaning: 1–7: plastics/20–22:
paper and fibreboard/80–98:
composite materials .
Contact your local refuse
disposal authority for more
details of how to dispose of
your worn-out product .
3 ] [
16 ] [