Hamilton Beach Commercial BLIZZARD BIC3000-DQ Manuel D'utilisation page 5

Installation
Electrical Requirements
w WARNING
Electrical Shock Hazard.
• Plug into a grounded 3-prong outlet.
• Do not remove ground prong.
• Do not use an adapter.
• Do not use an extension cord.
Observe all governing codes and ordinances. A 120-volt, 60-Hz, AC-only,
15-amp, fused electrical supply is required (a time-delay fuse is recommended).
It is recommended that a separate circuit serving only this equipment be provided.
Installing the Blizzard
Excessive Weight Hazard. Use two or more people to move and install equipment. Failure to
w WARNING
do so can result in serious injury or damage to the equipment.
w WARNING Crush Hazard. Follow instructions below for bolting to the countertop to avoid unit tipping over.
1. Begin by unboxing the machine and placing it on a side table
or countertop. Inside the cardboard tube will be a parts kit.
2. Make sure Blizzard
into electrical outlet. At the rear of the machine, near the
bottom, notice:
• The push-to-connect fitting to install the water line.
• The stability brackets to secure the machine to the table.
• The exit point of the drain pipe using 3/4" PVC pipe.
NOTE: It may be prudent to take some masking tape
and outline where the machine could go on the countertop.
The footprint of the machine is approximately
7 / " x 21 / " (19.7 cm x 54.0 cm).
3 1
4 4
3. Install the factory-supplied black ABS drain pipe into the
machine by sliding it into the rear of the machine and into
the socket of the washer chamber. Look inside the rear of
the machine to see where the wash chamber socket it is
supposed to connect to.
4. Tighten the flexible coupler to the drain pipe. Firmly twist and
press the drain pipe into the wash chamber socket.
5. Mount the machine to the table.
Either use bolts (recommended):
840297500 EN v13 English_FR.indd 5
(cont.)
• Failure to follow these
Machine
®
Machine has not been plugged
®
Alternatively, use two C-clamps:
instructions can result in
death, fire, or electric shock.
5
5/4/18 12:05 PM