Hamilton Beach Commercial BLIZZARD BIC3000-DQ Manuel D'utilisation page 14

Installing Top Shield Assembly
18. Install the top shield by first noting the front of the
shield (marked with "F"), sliding the shield onto
the motor shaft and guide rods, and inserting
the two (2) cotter pins.
19. Install the agitator onto the motor shaft, rotating the agitator
counterclockwise until it is just snug. Do not overtighten. The
agitator will self-tighten as it blends.
20. Install the shield cover and secure with thumbscrews.
21. When ready for service, turn the machine on. It will ask you to
press Flush to rinse the wash chamber. When the flush cycle is
complete, the prompt will ask you to press Up Arrow to confirm
the drain is clear (you will need to open the control panel cover
to press Up Arrow).
14
840297500 EN v13 English_FR.indd 14
Motor Shaft
Guide Rods
Cotter Pins
Top Shield
5/4/18 12:06 PM