Using The Audio Input; Led Indicators - Geemarc Loophear 102 Mode D'emploi

USING THE LoopHEAR

Using the Audio Input

The LoopHEAR
external audio source like a TV set , MP3-4 , computer.
Connect your audio equipment to the 3.5mm socket
(blue) on rear panel of your LoopHEAR
then hear the magnetic signal when you are within 1
meter of the LoopHEAR
the "T" position.
The sensitivity can be adjusted by turning the control
at the rear with a small flat screw driver.

LED Indicators

The unit has various LED indicators located in the handle recess
area, which light up as follows :
1. Blue LED flashes in sync with the Field Strength LED on the
front.
2. If the AC adaptor is plugged in
- White LED lights up if the battery is charging.
- White LED changes colour to Green when the battery is fully
charged.
3. If the AC adaptor is not plugged in and the unit is switched ON
- All LEDs except the Blue one will be off if the battery has
adequate charge.
- Red LED lights up when the Battery voltage is low. When the
Red LED lights up Plug in the Power Adaptor immediately to
charge the battery.
TM
can transmit sound through the loop from an
14
TM
with your hearing aid in
TM
TM
. You will