Publicité
NOTICE! After selecting the end node, you can press
program directly.
Cleaning and maintenance
Use a clean, soft cloth moistened with a small amount of anhydrous alcohol to clean the taper holes in the
instrument's blocks. This ensures full contact and efficient heat conduction between the test tube and the
taper holes, while preventing contamination.
If stains appear on the instrument's surface, clean it with a soft cloth and a mild cleaning paste.
CAUTION
Ensure the power supply is turned off before cleaning the instrument.
DO NOT allow cleaning agents to enter the taper holes during cleaning.
Avoid using corrosive cleaning agents on the instrument's surface.
Disposing of used devices
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device
recycling and collection point. Check the symbol on the product, instruction manual, and packaging. The
plastics used to construct the device can be recycled following their markings. By choosing to recycle you are
making a significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
EN
Operate the multi-point program
button to run the multi-point
Publicité
