Publicité
Operation instructions
1. Single-point program setting
a)
Turn on the power switch, the display is shown in the figure below.
The instrument will initialize, accompanied by a "Beep" sound.
b)
After 6 seconds, the display will show: "S1" as the last operating node, "30.0" as the current
temperature of the blocks, "37.0" as the previously set temperature, and "10:00" as the previously
set time. The temperature is displayed in "℃", and the time is shown in "hours: minutes". The display
is shown in the figure below.
c)
Press the
decimal place. If you long press the button for more than 3 seconds, the adjustment will quickly move
from the unit to the tens place, allowing for faster changes.
Press the
button for more than 3 seconds will cause the adjustment to move quickly from the unit to the tens
place, allowing for faster modifications.
e.g. To set the temperature to 40°C and the time to 2 hours from 37°C and 10 hours: Press the
button until it increases to 40°C, then release the button. The instrument will automatically
confirm and save the setting. Next, press the
then release the button. The instrument will confirm and save the time. The temperature and time
settings for the S1 node are now successfully configured. Press the
program. The display is shown in the figure below.
EN
value. For faster adjustments, long press "
position.
Timing Setting: Use the timing setting button to set the duration. Press "
and "
" to set the desired time. For quicker adjustments, long press "
and "
" to change the digit position.
Program Setting: Press the
start node defaults to S1. The following program sequences can be configured:
S1-S2, S1-S2-S3, S1-S2-S3-S4, and S1-S2-S3-S4-S5.
Start/Stop: Press the
again to stop the program.
button to adjust the temperature value by increasing or decreasing the
button to adjust the time value by increasing or decreasing it. Holding the
" and "
" to change the digit
button to select the endpoint node. The
button to begin the program operation. Press
button until the setting decreases to 02:00,
"
"
button to run the
Publicité
