Publicité
d)
Press the
For example, press the
temperature and time for S2. The display is shown in the figure below.
Follow the same steps to set the temperature and time values for nodes S1 to S5. These five
temperature points can be saved as commonly used settings, allowing the user to quickly select them
when needed.
2. Multi-point program setting
a)
Press the
connection programs, such as S1-S2, S1-S2-S3, S1-S2-S3-S4, or S1-S2-S3-S4-S5.
NOTICE! The temperature point of the multi-point program can only start from S1.
b)
E.g. To set a connection program for S1-S2-S3-S4, press the
current configuration, where S1 is the starting node (which cannot be changed) and S2 is the end
node (which can be modified). Press the
button to confirm the setting. The node configuration will be displayed as S1-4, and the program will
run through the S1-S2-S3-S4 sequence.
c)
Press
Operate the single-point program
button to select and set the 5 temperature points for S1, S2, S3, S4, and S5.
button to select S2, then follow the previous step (c) to set the
button to combine the temperature points of S1, S2, S3, S4, and S5 into multi-point
button again to run S1-S2-S3-S4 four-point connection program.
EN
button. The display will show the
button to change S2 to S4. Then press
Publicité
