Publicité
GENERATOR PREPARATION
The following section describes steps necessary to prepare the generator for use. If after reading this section,
you are unsure about how to perform any of the steps please call (872) 314-0005 Mon-Fri 9-5 EST for
customer service. Failure to perform these steps properly can damage the generator or shorten its lifespan.
Unpacking
Unpack the generator and all its parts. Do not discard the carton or any packaging until the
generator is completely assembled.
The generator fuel tank cap is not assembled, after received the device ,we can do as follows:
1. Tear the protective film on the fuel tank filling port.
2. Take the filter out from the fuel tank.
3. Put the mark on the fuel tank cap into the fuel tank, then put the filter back.
4. Now we can add the recommended gasoline into the tank normally.
Operating Location
●
Check the temperature and humidity for generator operating.
-- Applicable temperature: -5℃～40℃(23℉~104℉）
-- Applicable humidity: below 95%
●
Only use OUTSIDE and place the generating set in a well-ventilated area.
●
Only operate the generating set on a flat, level surface and in a clean, dry operating environment.
●
Allow two feet clearance on all side of the generating set while operating it outdoors.
●
Operate in specified area, if any problem on applicable occasion, please consult the authorized local
dealers. In some areas, generating set must be registered with the local utility. Generating set used to
construction sites may be subject to additional rules and regulations.
DANGER: The exhaust of the generating set contains carbon monoxide, using engine indoors
CAN KILL YOU! NEVER use inside any building or any kind of enclosure, EVEN IF doors and
windows are open. Place the generating set in a well-ventilated and clean area. Note the wind direction and
air current when place the generating set.
High Altitude
This generating set may require a high altitude carburetor kit to ensure correct operation at high altitudes.
Consult the authorized local dealer for high altitude kit information if you always operate your engine at
altitudes above 5,000 feet (1,500 meters).
CAUTION: Even with carburetor modification, generating set horsepower will decrease about
3.5% for each 1,000 feet (300 meters) increase in altitude. The effect of altitude on
horsepower will be greater than this if no carburetor modification is made.
Operation the engine at altitude below 5,000 feet (1,500 meters) with modified carburetor may cause the
generating set to overheat and result in serious engine damage. Please restore factory specifications of the
carburetor at the dealer when using the engine in a low altitude area.
Operating Condition
Check for loose or damaged parts, signs of oil or fuel leaks, and any other condition that may affect proper
operation. Repair or replace all damaged or defective parts immediately.
Clean the dirt or foreign objects on the surface around exhaust and air intake of generator. DO NOT move or
12
Publicité
