Publicité
• Supervise the device during operation in order to detect automatic shutdown or dry-
running of the pump in good time. Check the function of the float switch regularly (see
chapter "Commissioning"). Failure to do so will invalidate warranty and liability claims.
• Please note that the pump is not suitable for continuous operation (e.g. for watercourses
in garden ponds). Check the device regularly for proper functioning.
• Please note that lubricants are used in the device, which may cause damage or contamination
due to leakage. Do not use the pump in garden ponds with fish or valuable plants. If
lubricants leak out, they may contaminate the liquid.
• Do not use the cable or hose to carry or fastened the device.
• Protect the device from frost and dry-running.
• Only use original accessories and do not make any modifications to the device.
• Please read the information on "Cleaning, maintenance, storage" in the operating manual.
All other measures, in particular opening the device, must be carried out by a qualified
electrician. In the event of repair, always contact our service centre.
Electrical safety instructions
• The mains plug must remain freely accessible when operating the device.
• Before you put your new pump into operation, have it professionally checked:
• Earthing, connection of the neutral line and residual current circuit breaker must comply
with the safety regulations of the power supply companies and function properly,
• Protect the electrical plug connections from moisture.
• If there is a risk of flooding, fit the plug connections in the flood-proof area.
• Ensure that the mains voltage corresponds to the specifications on the type plate.
• Carry out the electrical installation in accordance with national regulations.
• Only connect the device to a mains socket with a residual current device (RCD) with a rated
leakage current of no more than 30 mA; fuse at least 6 amps.
• Before each use, check the device, cables and connectors for damage. Defective cables
must not be repaired but replaced with a new ones. Have damage to your device repaired
by a specialist.
• If the connection cable of this unit is damaged, it must be replaced by the manufacturer
or their service department or a similar qualified person in order to avoid hazards.
• Do not use the cable to pull the plug out of the outlet.
• Protect the cable from heat, oil and sharp edges.
• Do not carry or fasten the device by the cable.
• Use only extension cables that are splash-proof and intended for outdoor use. Always
unroll a cable drum completely before use. Check the cable for damage.
• Disconnect the mains plug from the socket before carrying out any work on the device, as
well as during breaks in work and when not in use.
• Mains connection cables shall not have a smaller cross-section than rubber hose lines
with the designation H07 RN-F. The cable length must be 10 m. The conductor core
cross-section of the extension cable must be at least 1.5 mm
www.scheppach.com / service@scheppach.com / +800 4002 4002
.
2
GB | 25
Publicité
