Bimar VP455T Notice D'instructions page 13

• Before connecting the appliance, check that the voltage values shown on the data plate
correspond to those of the electricity supply network. In the event of incompatibility between the
electric outlet and the plug of the appliance, have the outlet replaced with another more suitable
type by professionally qualified personnel, who will make sure that the section of the wires of the
outlet is appropriate for the absorbed power of the heater. In general, the use of adapters or
extension cords is not recommended; if their use is indispensable, they must conform to existing
safety standards and their current capacity (amperes) must not be less that the maximum of the
appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• To not place the appliance near sinks or other container of liquids (minimum distance of 2 meters)
to avoid the risk of it falling in.
• Do not place the appliance near an open flame, cooking or other heating appliance.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air
intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or
wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the
appliance could upset).
ASSEMBLY
Before assembling the fan, make sure it is unplugged from the socket.
The appliance can only be used once correctly assembled in all its parts, complete with counterweight
base, protective grills, propeller.
Proceed as shown and use the images for reference.
A. Unscrew and remove the ring nut (6) from the column, insert the ring (3), and tighten the ring nut
again.
B. Set the column (14) in place on the base and secure it using the "L" screw with washer (1) while
also engaging the counterweight.
C. Make sure column and base and counterweight are firmly coupled.
D. Unscrew the ring nut (15) and the ring nut (16) (turn clockwise) from the motor body.
E. Insert the rear grill (12) into the motor body, make sure the handle is at the top and lock it using
the ring nut (15).
F. Insert the propeller (13) onto the drive shaft (5) and lock it with the ring nut (16) (turn counter
clockwise and tighten).
G. To fasten the front grill, it is best to place the main unit on a smooth even floor. Couple the front
grill (11) to the rear (12) and hold in place with plastic ring, (a fixing screw is good at the bottom)
and secure fastening by tightening screw (10).
H. At the end of the operation, check that the protective grills are firmly coupled and attached to
the motor.
13