Sony SU-WB1 Informations D'installation page 2

Installation Information for Using
Sony Sound Bar Bracket (SU-WB1)
To use the SU-WB1 Sound Bar Bracket, you need to attach it to the SU-WL905 or SU-WL900
Wall-Mount Bracket, which is sold separately.
Whether the SU-WB1, SU-WL905 or SU-WL900 can be attached depends on your TV's or LCD
Display's specifications.
For more details, refer to below page:
SU-WB1: https://www.sony.net/su-wb1-wall-mount-bracket
SU-WL905 or SU-WL900: https://www.sony.net/wall-mount-bracket
ˎ Applicable Sound Bars: BRAVIA Theatre Bar 9 (HT-A9000), BRAVIA Theatre Bar 8 (HT-A8000),
BRAVIA Theatre Bar 6 (HT-B600), BRAVIA Theatre System 6 (HT-S60), HT-A5000 and HT-A3000.
ˎ Required TV or LCD Display specification: The distance from the bottom edge of the TV or
LCD Display to the lower screw for the wall mount (labeled as  in the diagram below) should
be approximately 88 mm to 155 mm.
A
To Customers
For product protection and safety reasons, Sony strongly recommends that installation of your TV or
LCD Display with Sound Bar be performed by Sony dealers or licensed contractors. Do not attempt
to install it yourself.
To Sony Dealers and Contractors
Provide full attention to safety during the installation, periodic maintenance and examination of this
product.
Sufficient expertise is required for installing this product, especially to determine the
strength of the wall for withstanding the TV or LCD Display with Sound Bar weight. Be
sure to entrust the attachment of this product to the wall to Sony dealers or licensed
contractors and pay adequate attention to safety during the installation. Sony is not
liable for any damage or injury caused by mishandling or improper installation.
For Safety and proper installation, follow the Sound Bar Bracket Instruction Manual, TV or LCD
Display Instruction Manual, and the directions in this manual.
− 2 (EN) −