Preparing The Remote Control; Installing Batteries In The Remote Control - Yamaha YSP-1 Mode D'emploi

PREPARING THE REMOTE CONTROL

Installing batteries in the remote
control
%
Press
1
Press the mark on the battery cover and
slide off the cover.
2
Insert the two supplied batteries (AA, R06,
UM-3) into the battery compartment.
Make sure you insert the batteries according to the
polarity markings (+/–).
3
Close the battery cover.
18
PREPARING THE REMOTE CONTROL
Notes on batteries
• Change all of the batteries if you notice the following
conditions; the operation range of the remote control
decreases, the indicator does not blink or its light
becomes dim.
• Do not use old batteries together with new ones.
• Do not use different types of batteries (such as alkaline
and manganese batteries) together. Read the packaging
carefully as these different types of batteries may have
the same shape and color.
• If the batteries have leaked, dispose of them
immediately. Avoid touching the leaked material or
letting it come into contact with clothing, etc. Clean the
battery compartment thoroughly before installing new
batteries.
If the remote control is without batteries for more than
2 minutes, or if exhausted batteries remain in the
remote control, the contents of the memory may be
cleared. When the memory is cleared, insert new
batteries and reset the remote control codes.
When changing the batteries, be careful not to press
any of the buttons on the remote control.
Doing so will clear the contents of the memory.