Bosch EasyGrassCut 18 Notice Originale page 27

Continuous Lighting of the Green Battery Charge
Indicator
Continuous lighting of the green battery
Full
charge indicator indicates that the battery is
fully charged.
When the battery is not inserted, continuous lighting of the
battery charge indicator indicates that the mains plug is in-
serted in the socket outlet and that the battery charger is
ready for operation.
Continuous Lighting of the Red Battery Charge Indicator
Continuous lighting of the red battery charge
indicator indicates that the temperature of the
battery is not within the allowable charging temperature
range, see section "Technical Data". As soon as the allowable
charging temperature range is reached, the battery charger
automatically switches to rapid charging.
Flashing Red Battery Charge Indicator
A flashing red battery charge indicator indic-
ates a different malfunction of the charging
procedure, see section "Troubleshooting – Causes and Cor-
rective Measures".
Operation
Switching On and Off (see figure H)
To switch on, firstly press the lock-off button (3). Then
press the On/Off switch (4) and keep it pressed.
To switch off, release the On/Off switch (4).
Lawn Trimming/Edge Cutting (see figure I)
Turn the handle against the shaft by 180° to position the
trimmer head either for lawn trimming or edge cutting. Re-
lease button (2) so that the turning mechanism engages.
Now, turn the complete machine to the working position.
Troubleshooting
d.c.
Lawn Trimmer/Lawn Edge Trimmer
Problem Possible Cause
Motor refuses to start Battery discharged
Battery too hot/cold
Garden tool functions On/Off switch defective
intermittently
Internal wiring of garden tool defective
Garden product la- Grass too high
bours
Garden tool does not Cutting line too short/broken off
cut
Spool empty
Bosch Power Tools
Lawn trimming
Move the trimmer left and right, keeping it well away from
the body. Cut higher grass in steps.
Edge cutting
Guide the trimmer along the edge of the lawn. Avoid contact
with solid surfaces or walls to prevent rapid wear of the cut-
ting line.
Cutting around trees and bushes
Carefully cut around trees and bushes so that they do not
come into contact with the cutting line. Plants can die if you
damage the bark.
Dismounting the spool, winding up the cutting
line and mounting the spool (see figures J to L)
Remove the battery before replacing the spool.
u
Press both latches of the spool cover together and remove
the spool cover (11). Afterwards, remove the empty spool
(12).
Cut off approx. 4.0 m line from the refill roll. Slide one end of
the cutting line into the hole for line wind-up (13) in the
spool and wind up the cutting line uniformly and tightly.
Slide the other end of the cutting line through the hole for
line guiding (14) in the trimmer head and mount the spool
back into the trimmer head. Affix the spool by mounting the
spool cover (11).
Line Feeding (see figure M)
Semi-automatic Line Feeding
The trimmer is equipped with a semi-automatic feeding sys-
tem. The system feeds 10 mm of the line with every press of
the on/off switch (4).
Manual Line Feeding
Press the line-feed button (15), and pull the cutting line out
to the desired length.
Corrective Action
Recharge battery
Allow to cool/warm
Contact Bosch customer service agent
Contact Bosch customer service agent
Cut in stages
Manually feed cutting line
Replace line spool
English | 27
F 016 L81 795 | (26.10.2018)