Functional Description - Makita AN250HC Manuel D'instruction

FUNCTIONAL DESCRIPTION

CAUTION:
Always disconnect the air hose before adjusting or
•
checking function on the tool.
Adjusting the pin-driving depth
CAUTION:
Always disconnect the hose before adjusting the
•
pin-driving depth.
010308
1 2
010309
If pins are driven too deep, turn the adjuster clockwise.
If pins are driven too shallow, turn the adjuster
counterclockwise.
The adjustable range is 10 mm (3/8"). (One full turn
allows 0.8 mm (1/32") adjustment.)
Hook
CAUTION:
Always disconnect the hose when hanging the tool
•
using the hook.
Never hang the tool on a waist belt or like.
•
Dangerous accidental firing may result.
010310
The hook is convenient for hanging the tool temporarily.
This hook can be installed on either side of the tool.
1. Adjuster
1
1. Too deep
2. Flush
3
3. Too shallow
1. Screw
2. Hook
1
2
When changing the installation position, remove the
screw with a screwdriver. Install the hook on another
side for installation and then secure it with the screw.
Use the nose adapter
CAUTION:
Always disconnect the hose before installing or
•
removing the nose adapter.
010311
Always use the nose adapter. Otherwise a slippage may
occur or even the nailer may not fire the nail.
Usually use one of two nose adapter A (transparent) ,
one factory-installed on the contact element and the
other stored below the grip.
When working on narrow partition tracks, use nose one
of two nose adapter B (black) which are provided with in
the tool carton box.
To attach the nose adapter to the contact element,
press it onto the contact element as far as it will go.
Locking the trigger
This nailer is provided with the mechanism for locking
trigger to avoid personal injuries and property damage
caused by improper operation during other than pin-
driving operation.
010306
Set the change lever to the LOCK position to lock the
trigger.
5
1. Contact element
2. Nose adapter
1
2
1. LOCK position
1