Withings Body Comp Guide Utilisateur page 14

14
Warnings & safety notice
!
EN
FR
- Portable RF communications equipment (including peripherals
DE
such as antenna cables and external antennas) should be
SV
used no closer than 30 cm (12 inches) to any part of the device,
NL
including cables specified by the manufacturer. Otherwise,
FI
degradation of the performance of this equipment could result.
DA
- Use of this equipment adjacent to or stacked with other
IT
equipment should be avoided because it could result in
ES
improper operation. If such use is necessary, this equipment
CS
and the other equipment should be observed to verify that they
PL
are operating normally.
PT
- Do not interconnect this equipment with other equipment not
RO
described in the product guide.
HU - Follow operational and storage conditions as described
in the technical specifications section of this guide. Otherwise,
SK
measurement results may be impacted.
- Avoid using the device on feet with poor skin integrity, such as
cuts, wounds or damaged skin.
- No modification of this equipment is allowed.
- The use of medication with anticholinergic agents may impact
Nerve Health Score results. Ask your doctor about the medications
you take if you are not sure whether they have anticholinergic
properties.
- Drinking alcohol 24 hours prior to taking a measurement may
affect the results of the Nerve Health Score.
- Measurement results may be impacted in case of lower limb
amputation.
How to use Withings Body Comp
and take a first measurement
- Follow the information in the Quick Start Guide and in the
Withings application to set-up your device.
- To wake up your device for the first time, please pull the tab in
the battery cover. If there is no tab, press the power button for
3 seconds if needed. Once your product is installed and
configured, it will appear in your Devices list in settings.
- To take the first measurement, step on the scale with bare feet.
Your name, or trigram (as configured in the Withings application),
will appear on the scale's screen at the end of the weight
measurement: it means your scale has correctly identified you
and the measurements sequence (as defined in the Withings
application) will follow.
- If it is not the case, the measurement will most likely appear
in "Unknown Measurements" in the application. Please assign
it to your user so that the scale can automatically recognize
the user during the next weigh-in.