Yamaha RD250 Manuel Du Propriétaire page 16

(2) Starting
1. Insert the key and turn the main
switch to the #1 position "ignition."
See page 4.
2. Turn the fuel petcocks to the " O N "
Position.
COLD ENGINE
3. Push down on the Starter jet lever on
the carburetor.
Do not open the throttle. See page 8.
WARM ENGINE
4. Unfold the kick pedal lever, engage the
kick gear by depressing the pedal until
pressure is feit, and kick through.
Or depress the Starter button.
5. After the engine fires, allow it a warm
up period of a minute or two. If the
Starter jet wasengaged, raise it back to
the off position prior to starting out.
- 14 -