Breakdown Assistance; Maintenance And Information; Replacement Parts; Accessories - Weller WFE 2S Mode D'emploi

English
Decommissioning
Attention!
A high concentration of pollutants will result in the active car-
bon heating up. The equipment should be run for several
minutes in a pollutant freestate before being switched off in
order to prevent unwanted heating up.

5. Maintenance and information

Different fluxes and flux constituents and the amount of and
size of dust particles in the extracted air will signifi cantly
effect the filters working life.
Submicron particles in the extracted air increase when sol-
dering or welding to varnish insulated wire. When working
with varnished wire replace standard pre filter F5 with filter
F7 (advise part no.)

4. Breakdown assistance

Malfunction Cause
Extraction Pipe system
power missing leaking Filter
is dirty Turbine
speed too low
Loud extraction Air speed through
noises extractionarm is too
high speed
WFE2S is Thermally switched
not running off
Filter display is Minimum pressure
not working hose was not
replaced after the
filter change
Sub-micron Pre-filter has not
particle becoming been used
dirty to quickly
13
When working with adhesives, a wide band gas filter without
sub micron filter should be used.
Filter change
Remove the plug from the mains socket, release the tension
buckles (4) and separate the filter housing (2) and the turbi-
ne housing (8). Unplug the minimum pressure hose and
release the filter latches, the compact filter can now be
removed.
Reverse this procedure to refit the filter.
Attention!
The minimum pressure hose must be reconnected correctly
and the holding latches must be turned downwards when
replacing the filter.
Contaminated filters must be treated as special waste.

6. Replacement parts

Solution
See Exploded page 58 for replacement parts for
Reseal the pipe standard installations
system Change T005 87 359 37 Fine dust filter F5
the filter T005 87 359 38 Fine dust filter F7 (Scope of shipment)
Increase the T005 87 359 36 Compact filter for adhesive vapours,
speed setting
Reduce the air T005 87 358 95 Wide band gas filter without sub micro
speed (reduced
air quantity)

7. Accessories

Preliminary separator 0058735862
Leave the WFE2S Easy Click 60
to cool down
Switch on again

8. Scope of shipment

afterapprox.
3 hours WFE 2S incl. filter
Connecting cable
Operating manual
Reconnect the Safety information
hose to the filter
Diagram Illustration page 56
Exploded Illustration page 58
Subject to technical alterations and amendments!
Use a pre-filter
Fit an F7 filter See the updated operating instructions at
Use a www.weller-tools.com.
preliminary
separator if the
proportion of
solid matter is
high.
comprising wide band gas filter
(50 % activated carbon, 50 % Puratex)
(Scope of shipment)
filter