Confirming Information About This Unit; Setting The Direct Power; Setting The Key Lock - Sony PC-3000 Mode D'emploi

Confirming Information About
This Unit
You can confirm the serial number and the ROM
version of this unit.
1
Enter the service mode and press the CONTROL
button.
The CONTROL MENU SET INFORMATION
display appears.
CONTROL MENU
SET I NFORMAT I ON
2
Press the SET button.
The serial number and the ROM version appears.
SER. No. 1000001 S
ROM Ver. 1.00

Setting the Direct Power

When the direct power is set to ON, you can turn the
switcher on or off with the MAIN POWER switch.
When the MAIN POWER switch is turned on, you can
also turn on or off with the breaker switch.
1
Enter the service mode and press the CONTROL
button.
2
Press the > or . button until the CONTROL
MENU DIRECT POWER display appears.
CONTROL MENU S
D I RECT POWER
3
Press the SET button.
The DIRECT POWER setting display appears.
D I RECT POWER S
>ON >OFF
4
Press the ? or / button to flash ON.
5
Press the SET button to enter the setting.

Setting the Key Lock

When the key lock is set to ON, the POWER ON/OFF
switch, PROJECTOR INPUT SELECT button and
SELECT button of the switcher does not function. It is
convenient to control the switcher with a computer
which is connected by the RS-422A. Even if the key
lock is set to ON, the CONTROL, SET and >/./?/
/ buttons will function.
1
Enter the service mode and press the CONTROL
button.
2
Press the > or . button until the CONTROL
MENU KEY LOCK SETTING display appears.
CONTROL MENU S
KEY LOCK SETT I NG
3
Press the SET button.
The KEY LOCK SETTING display appears.
KEY LOCK SETT I NG S
>ON >OFF
4
Press the ? or / button to flash ON.
5
Press the SET button to enter the setting.
When pressing the locked button in the key
lock mode
The following message appears for about 3 seconds.
KEY Locked
27
(EN)