essentiel b ELS814-1b Notice D'utilisation page 72

• The washer-dryer requires a mains supply of 220-240 V, 50 Hz.
• The power cord of your machine is equipped with a grounding plug.
• The plug must always be plugged into a grounded 10-amp outlet. The fuse rating of
the plug must also be 10 amps.
• If the plug or fuse does not meet these requirements, a qualified electrician should be
consulted.
• We accept no responsibility for any damage resulting from the use of ungrounded
equipment.
NOTE: The use of the low voltage machine will shorten its life and its performance
will be limited.
Water supply hose connector
• Connect the washer-dryer to a cold water supply only.
• Use the supplied water inlet hose or any other hose sold by an authorized distributor
only.
• The hose package includes a gasket against possible leakage at the fittings. Install
the gasket on the end of the water inlet hose to be connected to the tap.
• Connect the bent end of the water inlet hose to the cold water inlet at the rear of the
machine and tighten manually.
• Screw the other end of the water inlet hose onto a 3/4" tap and tighten by hand.
• If in doubt, consult a qualified plumber.
• Turn on the cold water tap and check for leaks.
72
3/4 "
1
3
2
4