Cleaning And Maintenance - elem Garden Technic TDE3213CBE21 Traduction Des Instructions D'origine

> Information on correct mowing
We recommend that you mow in overlapping lines.
Only mow with sharp, perfect blades so
that the blades of grass do not fray, making the lawn
turn yellow.
The cutting height should be between 4 and 6 cm
and the growth before the next cut should be
between 4 and 5 cm. If the lawn grows longer than
this on occasion, do not make the mistake of cutting
to normal length straight away since this will
damage the lawn.
Never cut the grass by more than half its height.
Keep the underside of the mower casing clean and
remove all grass deposits from it. Deposits make it
more difficult to start the mower and also adversely
affect the mowing quality and the grass discharge.
On slopes mow across the slope (not in up or down
direction).You can counteract the tendency of the
mower to slide down the slope by setting it at an
angle upwards.
that you do not remove more than 4 cm of grass
length in any one pass.
Switch off the motor before you carry out any
inspections of the blade. Remember than the
blade will continue to turn for a few seconds after
the motor has been switched off. Never
attempt to stop the blade.
Check regularly that the blade is correctly secured,
in good condition and well ground. If not,
grind or replace the blade. If the moving blade
strikes an object, stop the mower and wait until
the blade has come to a complete standstill. Then
check the condition of the blade and the
blade holder. If they are damaged, they must be
replaced.
Place the mains lead in loops on the ground in front
of the socket. Mow away from the socket
and cable and ensure that the mains lead is always
on the section of lawn that you have already mowed
so that you do not run over the mains lead with the
mower. As soon as you see mown grass on the
lawn whilst you are mowing, the grass bag will need
emptying.

CLEANING AND MAINTENANCE

Before performing any work
on the equipment, pull out
> Cleaning
§ Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it with
compressed air at low pressure.
§ We recommend that you clean the device
immediately each time you have finished using it.
§ Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the
device.
Never use solvents such as
petrol, alcohol, ammonia
water, etc. These solvents
may damage the plastic
> Blade maintenance
§ Regularly remove grass and dirt from the blade.
§ At the beginning of the gardening season,
carefully examine the condition of the blade.
§ If the blade is very blunt, sharpen or replace the
blade.
§ If the blade is damaged or worn, fit a new blade.
Observe the following
§ Disconnect the mower from the mains and wait
until the blade has stopped rotating before
proceeding.
§ Be careful not to cut yourself. Use heavy-duty
gloves or a cloth to grip the blade.
§ Only use the specified replacement blade.
§ Do not remove the impeller (A)for any reason.
Attention!
the power plug.
parts.
Warning!
precautions:
40